Editing 3D Printing

Jump to: navigation, search

Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision Your text
Line 38: Line 38:
 
TODO:
 
TODO:
  
βˆ’
* Install the part cooling shroud and 24v fan - done!
+
* Install the part cooling shroud and 24v fan
  
βˆ’
* Tighten heat block (mysteriously it's working fine as is)
+
* Tighten heat block
  
 
* Install a Bowden cable and attach the wire to it to prevent it from interfering/getting crushed by the gantry.
 
* Install a Bowden cable and attach the wire to it to prevent it from interfering/getting crushed by the gantry.
  
βˆ’
* Install cotton insulator for heat block (upgraded cooler sometimes cools this area too much.  Until then, do not run the fan at 100% out it will give you a heater error.
+
* Install cotton insulator for heat block (upgraded cooler sometimes cools this area too much.
  
 
== Monoprice Miniprinters ==
 
== Monoprice Miniprinters ==

Please note that all contributions to Noisebridge are considered to be released under the Creative Commons Attribution-NonCommercial-ShareAlike (see Noisebridge:Copyrights for details). If you do not want your writing to be edited mercilessly and redistributed at will, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource. Do not submit copyrighted work without permission!

To protect the wiki against automated edit spam, we kindly ask you to solve the following CAPTCHA:

Cancel Editing help (opens in new window)