Editing 3D Printing

Jump to: navigation, search

Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision Your text
Line 186: Line 186:
 
5/27/19 (Derek Redfern)
 
5/27/19 (Derek Redfern)
 
* Shifted PINDA sensor slightly downwards and ran full XYZ calibration. Got most of the way through but it didn't seem to detect cal point #4 on the second round (smooshed the tip and PINDA sensor into the bed). Working from sections 6.3.5 and 6.3.10.2 in the [https://www.prusa3d.com/downloads/manual/prusa3d_manual_mk2_en.pdf manual].
 
* Shifted PINDA sensor slightly downwards and ran full XYZ calibration. Got most of the way through but it didn't seem to detect cal point #4 on the second round (smooshed the tip and PINDA sensor into the bed). Working from sections 6.3.5 and 6.3.10.2 in the [https://www.prusa3d.com/downloads/manual/prusa3d_manual_mk2_en.pdf manual].
βˆ’
 
βˆ’
== M3D Micro ==
 
βˆ’
Very slow printer, though also low-fuss. Appears to be working but I haven't yet taken the time to wait for a print to get all the way through. Not good for very large or very fine prints.
 
  
 
= Filaments =
 
= Filaments =

Please note that all contributions to Noisebridge are considered to be released under the Creative Commons Attribution-NonCommercial-ShareAlike (see Noisebridge:Copyrights for details). If you do not want your writing to be edited mercilessly and redistributed at will, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource. Do not submit copyrighted work without permission!

To protect the wiki against automated edit spam, we kindly ask you to solve the following CAPTCHA:

Cancel Editing help (opens in new window)