Editing BicycleLighting
Jump to navigation
Jump to search
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then publish the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 44: | Line 44: | ||
=== parts === | === parts === | ||
* 1x or 2x 555 timer chips | * 1x or 2x 555 timer chips | ||
* 1x photoresistor | * 1x photoresistor | ||
* various resistors & capacitors to produce the right 555 outputs | * various resistors & capacitors to produce the right 555 outputs | ||
* 1x fabric pressure sensor | * 1x fabric pressure sensor | ||
Line 54: | Line 52: | ||
=== current state === | === current state === | ||
I have the 555 circuit modelled for a nice rate of flash for the rear LEDs, using 3V. | I have the 555 circuit modelled for a nice rate of flash for the rear LEDs, using 3V. | ||
=== next step === | === next step === | ||
Figure out how to translate the photoresistor's output into an ON/OFF signal. Then calibrate the amount of light. I can create the seat cover with embedded pressure switch whenever, it's just a switch, so it can wait until last. | |||
I can create the seat cover with embedded pressure switch whenever, it's just a switch, so it can wait until last. | |||