Epson Stylus Pro 4880
The Epson Stylus Pro 4880 is an 18" roll printer equipped for photo printing. There are two of them! The first one is located near the laser printer. The other is attached to the Ordibooth as an optional full color photographic output mode!
Ink cartridges run in the hundreds of dollars, so if you run a print job for more than a 2"x2" passport photo, drop some dollars in the donation bin.
Please, sometimes replace the power towels in the maintenance tank.
As of 07-20-2017 the Ordibooth Epson has a mechanical paper jam.
You'll need the software to print.
On Linux, the Gutenprint driver system has high quality photo priting support. On Debian, the package names are
gimp-gutenprint escputil printer-driver-gutenprint foomatic-db-gutenprint
There is a manual. There is a paper copy of the user's guide in the space.
- Install software
- Make sure you have the right paper
- Know what you are doing
- There's a manual
We have not refilled cartridges yet. The cartridges have a chip that estimates as the ink goes down. We need to use a chip resetter on an empty cartridge to tell it that it is full again. Trent has a chip resetter.
Some Error Messages
Here is a list of error messages.
Error Messages We Have Seen
MNT TNK NOT INST - The maintenance tank had a bent pin when it arrived. I was able to gently unbend the pin. Let me know if this happens again, it requires a good amount of care and precision to fix.
MNT TK NEAR FULL - The maintenance tank is reusable. Gently pop the plastic grating off using a tiny flathead screwdriver in one of the six tiny holes on the side. Replace the paper towels inside. This needs to be done semi regularly so it does not overfill.
MNT TNK FULL - CHIP RESET - if the maintenance tank fills up, it is actually just an electronic chip claiming it is full. This chip needs reset using a "chip resetter", trent has one. The maintenance tank paper towels need replaced occasionally.
The nozzles need cleaned manually as the auto clean doesn't work and uses tons of ink.
An excellent youtube video guide exists.
It is necessary to press the allen screw in this video, allowing the print head to slide along its axis. Then use a blue shop towel with windex original to release any dried ink from the nozzle. The windex cannot be the foaming type, and it should have ammonia in it.
If it's not that clogged you can try using the nozzle cleaning utility run via the printer software.
Hacking the Chip
People hacked the chip and there was a lot to it. You can learn more here.
It may be possible to read any brand new chip that has never touched a machine and write it to the old one, but there's some weird stuff in eddiem's chip hacking article.