Editing New payload bus

The new payload bus will be based on a multi-level tower design made from laser cut plastic disks and carbon rods used to support the structure.

Currently, the plan is to encase the frame in Styrofoam tortilla warmers, which will serve both as isolation at altitude as well as destructible landing padding.

== components of payload ==

APRS Data modem:[http://www.rpc-electronics.com/rtrak-hab.php website]

[[File:Spacebridge_new_radio.PNG|500px]]

Android G1 Phone:

[[File:Spacebridge_G1.PNG|500px]]

Video Camera:

[[File:Spacebridge_video_camera.PNG|500px]]

Video Transmitter:

[[File:Spacebridge_video_TX.PNG|500px]]

Canon Still Camera:
Canon Powershot SD4500 IS

[[File:Spacebridge_canoncamera.PNG|500px]]

Tortilla Warmer:

[[File:Spacebridge_tortillafoam.PNG|500px]]

Proposed miniature assembly:

[[File:Spacebridge_smallpayload.PNG|500px]]

== Onno Ring ==

The payload design depends on plastic planar structures to act as mount points for all payload components, as well as load-bearing points for the balloon and parachute.

To facilitate this design, Onno has designed a revolutionary new geometric shape which has been estimated to be between 100x and over 9000x stronger, lighter, and cooler than an ordinary disk of the same material and approximate size. 

Onno Ring:

[[File:Spacebridge_onno_ring.PNG|500px]]

Balloon load bearing ring:

[[File:Spacebridge_onno_plate.PNG|500px]]

Standard mounting plate for cameras:
Please note, this does not use the Onno ring, so it is the weakest part of the design, by approximately 900000%.

[[File:Spacebridge_mount_ring.PNG|500px]]