Noise Square Table
During Maker Faire 2015 we built a new table for Noisebridge, called NoiseSquare.
This will be the documentation.
Woodwork
Most of the Table is 3/4" Red Oak finish plywood. Nearly all the external joinery is done with #20 biscuits and Titebond 3 wood glue. The internal structure is 3/4" CDX plywood with Kreg pocket screws and wood glue.
The stain is "American Walnut" from Minwax applied with t-shirt scraps and everything but the table top is Varathane Interior polyurethane applied with a foam brush in 3 coats.
The table top surface is finished with a flood coat of Ultra-Glo epoxy resin from Tap plastics. Below the table top is another layer of plywood which holds the LEDs. The Noisebridge logo was hand routed into both of these layers with a top bearing router bit.
Low Voltage Electronics
Electrical
Resin
PDF Plans
The .pdf of working drawings for the table are here:
https://noisebridge.net/images/a/a7/Noisebridge_MakerFaire_Table.pdf
History
Team Credits
Build Team: Jarrod Hicks, Howard Tsu, Julio Talavera, Torrie, Andrew, John, Amber,
MakerFaire Show Team: