PCB Etching Tutorial

From Noisebridge
Jump to navigation Jump to search

DIY PCB Etching : Using Chemicals

Chances are you've probably seen a PCB before and it might of looked a little something like this

[Insert a picture of an example of a PCB maybe a Raspberry Pi or an Arduino etc]

The most important part of a PCB is the traces which connect the components to each other. These traces made in a CAD program for PCBs like : Eagle CAD , KiCAD etc

[Insert Picture of traces here]

This tutorial will show you how to make a simple single sided PCB using a chemical method. In summary the traces will be transferred and covered in a solid copper board , then the parts of copper not needed will stay expoxed. Finally the parts not needed will be removed with chemicals.

[Insert picture of before and after here ]

PcbDone.jpg

Materials Needed

  • Single sided copper clad board -- [[ https://www.google.com/search?q=copper+clad+fr4&ie=utf-8&oe=utf-8]]
  • Circuit board trace layout in a printable format (pdf or postscript ps works, design this with an EDA program)
  • Glossy Inkjet Photo Paper (to print the traces on)
  • Iron or press
  • Etchant chemical
    1. Ferric Chloride Solution (to dissolve the copper from the board)
    2. Muriatic Acid
  • WetorDry paper
  • Container to put PCB in with chemical solution


Steps

If you are using Ferric Chloride(FeCl3) foretchant, then start heating your etchant to 50C


1) Preparing the Copper Board: Clean It

Make sure to clean any junk from the copper board before beginning the process!

  • Use WetorDry paper / fine sand paper to clean the PCB under water until it turns pink

Sandingboard.jpg

  • Wipe off water with a clean towel
  • Use acetone to remove oils from PCB

AcetoneClean2.jpg

[ insert Cleaning pics here]


2) Printing the Traces:

Grab your Laser printer and print the traces onto the glossy inkjet photo paper.

  • we used walgreens 8.5x11 stock inkjet photo paper with fine results
  • We used the Noisebridge Brother HL-5470DW and generic Laser printer toner with fine results
  • Make sure your print driver isn't scaling or distorting the circuit layout
  • Use monochrome and highest resolution possible for your printer

The printer operator should also take this opportunity to provide feedback to the circuit designer:

  • Make sure the design traces are thick enough for this process (XXmil/XXmm minimum trace width with 20mil/0.508mm minimum clearance)
  • Make sure the export file is mirrored. The Laser Printer toner is going to 'transfer' to the surface of the copper clad and become unmmirrored in the process

Tracesprinted.jpg


3) Transferring the Traces to the PCB:

* Press down the glossy paper with the design onto the copper PCB 

Tracestransfer.jpg

* Use a hot iron to press down glossy paper to the PCB 

Tracestransfer2.jpg

*After the glossy paper stick onto the PCB submerge the two in a tray of water and gently press down the paper so it peels off leaving the trace on the PCB 

Traceswaterdip.jpg

  • Once the paper starts to peel off under the water feel free to use your finger to gently peel the paper from the copper board

[[File:Tracespeel.jpg]]





4) Get Rid of the remaining Copper

*Place the Ferric Chloride Solution Bottle  inside tray of hot water (this will heat the solution and make the PCB copper to be dissolved faster) 
* Pour some of the solution into a tray along with your PCB 
* Check the PCB every 5 or so minutes to check if the copper has been fully removed
[insert PCB blood water pics here]