Difference between revisions of "Talk:DreamTeam/Brainduino"

From Noisebridge
Jump to: navigation, search
(gain calculation)
Line 1: Line 1:
 
what is value of c33? 50 pF or 1 nF ?
 
what is value of c33? 50 pF or 1 nF ?
 +
determines high-cut frequency either 160 Hz (1 nF) or 3200 Hz (50 pF)
  
 
Op amps ...
 
Op amps ...
OPA2111 - what gain?  
+
OPA2111 - what gain? expecting ~ 100 ?
 +
 
 
what values for R27, R23, R24 ?
 
what values for R27, R23, R24 ?
 
(also R28, R25, R26)
 
(also R28, R25, R26)
Line 9: Line 11:
 
R23, R24 -> 100K ohms
 
R23, R24 -> 100K ohms
  
cf instrumentation amp
+
cf instrumentation amp (figure 9 of http://www.ti.com/lit/ds/symlink/opa2111.pdf)
 +
1 + (R23 + R24) / R27 ...
 +
so 1 + (200 K / 2 K) = 101
  
 
2nd Stage AD8422 Instrumentation amp with gain resistor
 
2nd Stage AD8422 Instrumentation amp with gain resistor

Revision as of 06:12, 15 December 2016

what is value of c33? 50 pF or 1 nF ? determines high-cut frequency either 160 Hz (1 nF) or 3200 Hz (50 pF)

Op amps ... OPA2111 - what gain? expecting ~ 100 ?

what values for R27, R23, R24 ? (also R28, R25, R26)

R27 should be 2K ohms R23, R24 -> 100K ohms

cf instrumentation amp (figure 9 of http://www.ti.com/lit/ds/symlink/opa2111.pdf) 1 + (R23 + R24) / R27 ... so 1 + (200 K / 2 K) = 101

2nd Stage AD8422 Instrumentation amp with gain resistor 2(10 kΩ + RREF)/(20 kΩ + RREF) http://www.analog.com/media/en/technical-documentation/data-sheets/AD8422.pdf In figure 56, you will see that an op amp is used to input to the VREF pin.

3rd stage Low-cut (aka high-pass ) filter and DC offset to 3rd Stage OP2177ARMZ ( IC1B Ch1 and IC1A Ch2 )

4th Stage IC3D>IC3C Ch1, and IC3A>IC3B, Potentially considered a two-pole high-cut(aka low-pass)