[Fab] Cupcake operation

Nelson Zhang nelsonz at acm.org
Sun Apr 15 15:29:38 PDT 2012


I'll head back down tomorrow to try again - hopefully some version <= 29
will run properly on my computer. Thanks for the help!

Sincerely,
Nelson

On Fri, Apr 13, 2012 at 11:19 PM, Casey Callendrello <c1 at caseyc.net> wrote:

>  I successfully generated G-code and printed with replicatorg v.26. Just
> be sure to select the right skeinforge profile (cupcake w/HBP)
>
> -c.
>
>
> On 4/13/12 10:04 PM, Nelson Zhang wrote:
>
> Thanks for the advice - I tried using earlier versions, but repG28 and 29
> both had a bug where I couldn't pull up the control panel (I tried in both
> Windows and Ubuntu). Only 31 and above seemed to work. Have you encountered
> this problem before or do you know of a fix?
>
> Sincerely,
> Nelson
>
> On Fri, Apr 13, 2012 at 10:46 AM, miloh <froggytoad at gmail.com> wrote:
>
>> Hi Nelson --
>>
>> You can use up to ReplicatorG v29 to drive the Makerbot Cupcakes and
>> the SkeinForge version that comes bundled repG29 to slice prints for
>> the cupcakes at Noisebridge.
>>
>> I updated the Noisebridge Makerbot page to reflect this... links below
>>
>> https://www.noisebridge.net/wiki/Makerbot
>> http://replicat.org/
>>
>> -rma
>>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.noisebridge.net/pipermail/fab/attachments/20120415/837c39df/attachment.htm 


More information about the Fab mailing list