[Noisebridge-discuss] [Swarm] NB Logo - Stencilfied : Plasma Cutting at Boxshop
Steve " 'dillo" Okay (Roadknight Mobility Labs)
armadilo at gothpunk.com
Sat Jan 29 09:45:49 PST 2011
On Jan 28, 2011, at 01:15 , Corey McGuire wrote:
> Here's the sign.
> On Sun, Jan 23, 2011 at 8:44 PM, Corey McGuire
> <coreyfro at coreyfro.com> wrote:
> SUCCESS! Mostly. The cut quality was perfect at first, but then
> slowly degraded. The consumables were good enough. We think the
> air compressor couldn't keep up with such a long cut at such a low
> speed. The obvious solution is to insert pauses in to the cut
> execution or maybe even in the gcode its self. Also, at certain
> points, the machine wasn't tracking perfectly. We think it's due to
> bed wiggle after rapid moves between cuts. A possible solution is a
> pause after every rapid move. Another is to possibly add another
> horizontal brace to the bed, but that is easier said than done.
That's very nice!
More information about the Noisebridge-discuss