[Noisebridge-discuss] PCB fab places?
waywardengineer at gmail.com
Wed Nov 23 10:44:31 PST 2011
That Dorkbot PDX one looks like it might be a good solution actually, thanks!
On Wed, Nov 23, 2011 at 9:35 AM, Jonathan Foote <jtfoote at ieee.org> wrote:
> Local shops tend to be super-expensive for the deep pocket Silicon
> Valley folks who want a quick turnaround. Laen up at Dorkbot PDX has a
> great deal for small-volume boards, though:
> There's also Adafuit's PCB calculator, though that may not be up to
> date: http://www.ladyada.net/library/pcb/costcalc.html
> As always, the Engineering Rule of Two holds ("Fast, cheap, good: you
> only get to pick two")
> On Wed, Nov 23, 2011 at 12:15 AM, Ray <waywardengineer at gmail.com> wrote:
>> Does anybody know of a good place to get a pc board fabbed? I've
>> usually used gold phoenix for projects that need multiples of the same
>> design, but this time I just need one. It doesn't need more than 2
>> layers or anything fancy, does anybody have a favorite local place for
>> this kinda thing?
>> Noisebridge-discuss mailing list
>> Noisebridge-discuss at lists.noisebridge.net
More information about the Noisebridge-discuss