[Noisebridge-discuss] Laser engraver needs to go back in the DJ booth
jof at thejof.com
Thu Mar 15 21:43:36 PDT 2012
On Thu, Mar 15, 2012 at 9:37 PM, Corey McGuire <coreyfro at coreyfro.com> wrote:
> Not only does the air in the laser need evacuation, but so does the air
> around it. That is why the laser needs to be in a small, enclosed space like
> the dj booth... So it is easy to evacuate the air around the laser.
> We already solved this problem. The only reason it was moved was because of.
> The leak.
> Look, the sem doesn't need air exchange. Equipment that does has Window
> access priority. The sem is a novelty. It isn't a tool that will get much
> Until the laser has a permanent solution, there isn't really an argument.
Well, the argument posed above is that it should be somewhere with
minimal vibration. I don't think the DJ Booth fits that bill well
(though that's pure speculation on my part) -- it's a wood framed room
freely strutted above the staircase under it.
A better place (IMO) could be strapped against one of the support columns.
> On Mar 15, 2012 4:59 PM, "Andy Isaacson" <adi at hexapodia.org> wrote:
>> On Thu, Mar 15, 2012 at 01:03:24AM -0700, Alan Rockefeller wrote:
>> > If the current exhaust system is not good enough, we can add a turbine
>> > on the roof to pull the air much faster. When the laser cutter has
>> > significant negative pressure, you can not smell it even when standing
>> > right over it.
>> While the current exhaust scheme is quite ingenious, I hope it is just a
>> temporary hack and we can do something more permanent in the near
>> Noisebridge-discuss mailing list
>> Noisebridge-discuss at lists.noisebridge.net
> Noisebridge-discuss mailing list
> Noisebridge-discuss at lists.noisebridge.net
More information about the Noisebridge-discuss