[Noisebridge-discuss] Laser Cutter/Engraver

Casey Callendrello c1 at caseyc.net
Fri Nov 1 23:42:06 UTC 2013


On 11/1/13, 4:31 PM, Hilaire Nollette wrote:
> The proper operation of the laser requires you to start your cut with
> the energy nob set to the minimum setting, never turning it past
> half... If you turn it past half way... about 10-12mw the laser will
> die within the first few passes of printing... I will add this to the wiki
Just a FYI: The laser cutter power knob has already been modified to
only go half as far as originally provided. The cutter could
theoretically go to 30mw, but it won't go past 15mw now. So that's good.

Thanks for looking in to this!

--Casey


More information about the Noisebridge-discuss mailing list