[Noisebridge-discuss] New equipment for noisebridge :)

Winston Wolff winstonw at stratolab.com
Fri Dec 4 20:37:44 UTC 2015


Perhaps a trial period where Noisebridge hosts it for some pre-determined time and then a vote is taken to see if Noisebridge wants to keep it or not?

—Winston

Winston Wolff
tel: (917) 543 8852
web: www.stratolab.com

> On Dec 4, 2015, at 12:35 PM, Trent Robbins <robbintt at gmail.com> wrote:
> 
> Injection molding is suitable for low and high run work. My chief concern is how much -noise- and -space- it takes and how that overlaps with when they want to use it. Injection molding can apparently be done at low runs on some instruments using hand-fabricated molds, which I am very interested in.
> 
> T



More information about the Noisebridge-discuss mailing list