[Noisebridge-discuss] [sudo-discuss] SOIC-14 SOT-8 surface mounting reflow oven?
cere.misc at gmail.com
Sat Jul 11 02:06:57 UTC 2015
Thanks for the note Jake. I feel like my solder tip at home is going to be
too big for this, but thanks for the vote of confidence. I was thinking
about just getting a smt board from Adafruit and going from there instead
of all this crazy stencil stuff. Seems like a lot of work for just one or
On Fri, Jul 10, 2015 at 4:07 PM, Jake <jake at spaz.org> wrote:
> you can solder parts like that with an ordinary soldering iron, i can show
> you how. It's not hard. Do you have a PC board made yet?
> I'm assuming you have two or three chips per board. If you have like a
> dozen chips per board you might prefer to do it with stencils, which you
> can cut from transparent folder covers (thesis binder cover) with a laser
> cutter. Then once you have the solder paste in place, you put the chips on
> with tweezers and rest the board on a hotplate for 60 seconds.
> the other option is to dispense the solder paste with a 3d printer, like
> On Fri, 10 Jul 2015, Cere Misc wrote:
> So there's this chip that I just gotta have for a project I am working
>> on. The only problem is that it seems like EVERYTHING in IC form now it
>> packaged in these
>> teensy little surface mount chips. I don't have a small enough soldering
>> iron and I'd rather not hassle with trying to make it work with my shitty
>> Wondering if sudo or Noisebridge is set up for a solder reflow oven with
>> an accurate temperature control? Also, I am not totally clear about how I
>> create a
>> silkscreen soldering setup for a given PCB design. Does anyone on this
>> list have a lot of experience with this?
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Noisebridge-discuss