[Noisebridge-discuss] Moar Laser Cutter Infos

Eric Michaud michaud.eric.c at gmail.com
Thu Nov 12 21:51:38 UTC 2015


Hi James,

It sounds like we're duplicating work. I spoke with Mitch to learn who you
are and he said your totes awesome and we should meet to help each other
out. When are you at Noisebridge in the next few weeks? I'll do my best to
stop in there so we can expedite the laser system.

Best Regards,
-Eric.

On Wed, Nov 11, 2015 at 5:16 PM, James Sundquist <sundquistjames at gmail.com>
wrote:

> I actually did send a request for pricing on just that component to Full
> Spectrum 6 days ago, but they have yet to respond.
>
> That e-mail replicated below:
>
> Picture:
> https://moderndevice.com/wp-content/uploads/2012/06/fse-controller-768x1024.jpg
>
> We're a 501c3 non-profit hackerspace in SF and we're finally fixing our
> Lasercutter:
>
> *Full Spectrum Laser 4th Generation 40W CO2 Laser Engraver - Deluxe Model
> <https://noisebridge.net/wiki/Lasercutter/V4_Full_Spectrum_Laser_40W>*
>
> Our wiki page for it is found here:
>
> https://noisebridge.net/wiki/Lasercutter
>
> Please advise on availability and cost of a replacement board.
>
>
> _______________________________________________
> Noisebridge-discuss mailing list
> Noisebridge-discuss at lists.noisebridge.net
> https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.noisebridge.net/pipermail/noisebridge-discuss/attachments/20151112/4a1f3980/attachment.html>


More information about the Noisebridge-discuss mailing list