[Noisebridge-discuss] soldering copper sheet metal
Cere Mona Davis
ceremona at gmail.com
Sun Oct 25 23:58:19 UTC 2015
There is a special kind of flux for solding to copper. . Seen it at ace
hardware. Alternately, you can possibly try borax with a little water.
On Oct 25, 2015 4:37 PM, "jim" <jim at well.com> wrote:
> I've soldered electronics and plumbing and
> am stuck trying to solder copper sheet metal.
> I've used a soldering iron and a propane torch.
> I've used alcohol, acetone, and paint thinner
> to clean the copper as well as fine and coarse
> sandpaper to clean the surfaces. I'm using
> electronic flux (haven't yet tried plumbing
> The soldering is not working: solder does
> not flow or adhere to the copper, and there's
> a brown residue that appears after heating.
> Using a torch for forty or fifty seconds
> results in flame that does not immediately
> Anybody got tips?
> Noisebridge-discuss mailing list
> Noisebridge-discuss at lists.noisebridge.net
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Noisebridge-discuss