[Rack] samsys mp 9320 uses DHCP
jof at thejof.com
Thu Jan 31 03:31:06 UTC 2013
There doesn't seem to be any link up on port 34.
I see a link up on port 33 (10 Mbit, half-duplex; weird), but just a
Cisco/Linksys MAC address on the far end. Whatever that is
has 172.30.1.249, and port 2101 isn't open.
On Tue, Jan 29, 2013 at 7:30 PM, Jake <jake at spaz.org> wrote:
> i'm trying to get our RFID reader to communicate over ethernet. It's
> plugged in (to port 34 of the lower switch in susan via a black cable) and
> getting a link, but last night we were unable to "find" it on the network.
> We have found no information about setting its IP address or anything, but
> today I learned that it's set for DHCP from the factory. But no clue what
> its MAC address is. So i would like to know how to check with the DHCP
> server to see if it comes on, or anything like that.
> i found the following on the interwebs:
> The default TCP port is 2101 the SAMSys MP9320 reader driver will target
> when establishing connections to the SAMSys reader. [this suggests that
> port 2101 is open on the device]
> "The MP9320 is equipped with an optional TCP/IP Ethernet port and embedded
> IP device server. This reader is configured for automatic IP address
> allocation using the Dynamic Host Configuration Protocol (DHCP) Mode and
> the reader automatically extracts the IP address from the DHCP server. This
> is the default mode for the reader as it is shipped from the factory”
> Rack mailing list
> Rack at lists.noisebridge.net
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Rack